Quick answer
Use a 2-yard pack of 1" polypro belting for small, load-bearing straps: tote handles, bag shoulder straps, and DIY belts. Cut to length, seal the ends, and attach with reinforced stitching or hardware for a clean, durable finish.
Why polypro belting suits small strap projects
Polypro belting is lightweight, moisture-resistant, and holds its shape well under tension, making it a practical choice for handles and belts that see daily use. Unlike cotton webbing, it won't stretch out easily, but it also has a firmer hand that may feel stiffer against skin. For projects where a soft, pliable strap is preferred, consider a different material. A 2-yard pack gives you enough for one pair of tote handles (about 20–24 inches each) or a single adjustable belt, so plan your cuts before you start.
When 2 yards is enough—and when it isn't
Two yards (72 inches) covers most small bags and belts, but larger totes or crossbody straps may require more length. Measure your project's strap path and add 4–6 inches for seam allowance and hardware folds. If you need more than 72 inches total, buy two packs or choose a longer continuous length. Also note that polypro belting can be heat-sealed to prevent fraying, but it is not suitable for high-heat applications like ironing directly.
Step-by-step: making straps from a 2-yard pack
- Measure and mark your strap lengths: Lay your bag pattern or belt path flat and measure the total length needed, then add 4–6 inches for seam allowance and hardware folds. Mark cutting lines with a fabric marker or chalk. Common mistake: forgetting to add extra length for turning under at the ends, which leaves straps too short. Double-check your math before cutting—2 yards goes fast if you miscount.
- Cut the belting cleanly: Use sharp heavy-duty scissors or a rotary cutter with a fresh blade. Cut straight across the width in one firm motion to avoid jagged edges. Common mistake: using dull tools, which fray the belting and make sealing harder. A clean cut seals better and looks more professional.
- Seal the cut ends: Melt the cut edge briefly with a lighter or heat tool to fuse the fibers and prevent fraying. Keep the flame moving and stop as soon as the edge glistens—do not let it burn. Common mistake: overheating, which creates a hard, blackened lump that won't fit through hardware. Work in a ventilated area and test on a scrap first.
- Attach straps with reinforced stitching: Sew straps to your bag or belt base using a box-X stitch or at least two rows of straight stitching with polyester thread. Backstitch at both ends. Common mistake: using a single row of stitching, which can pull out under load. For heavy loads, add rivets or bartacks at stress points.
- Add hardware or finish the ends: If using buckles or D-rings, fold the belting through the hardware and stitch down securely. For belts, consider adding eyelets or a buckle set. Common mistake: skipping the fold allowance, which leaves raw edges exposed. Test the strap's length with hardware in place before final stitching.
Product facts
- 1" Polypro Belting & Strapping, 2 yd: Dritz 1" wide polypro belting is used for making straps and handles for totes and bags, and is also ideal for DIY belt making. This confirms the belting is purpose-made for the exact projects in this guide, so you can trust it for load-bearing straps.

1" Polypro Belting & Strapping, 2 yd

